G-Technology G-Speed eS Pro Guide de l'utilisateur télécharger pdf (Page 33)

p.33

Maintenance for Your Drive

Replace a Failed Disk Drive

The ATTO R680 RAID controller continually monitors the health of each of the disk

drives in G-SPEED eS Pro. In the event of a disk failure, you will be notied based

on the notications settings you entered in Set Up Alert Notications. The ATTO

CongTool service will report the failed drive and help you locate its physical posi-

tion in the G-SPEED eS Pro enclosure.

Mute the Alarm

If you have set up ‘audible alarms’, the ATTO RAID

controller will beep when a drive has failed, or other

critical event has occurred. To mute the audible alarm,

click on the Alert icon

in the System Notication

area of your desktop. Select ‘Mute Audible Alert’.

Note About Drive Failure

If the G-SPEED eS Pro was congured in RAID 1 or RAID 5 mode, a drive failure

does not necessarily result in data loss. However, the array is now in a degraded

and unprotected state; the failed drive should be replaced as soon as possible to

avoid data loss.

If G-SPEED eS Pro was congured in RAID 6 mode, up to two drives can fail with

no loss of data. Replace any failed drive as soon as possible.

Follow the steps on the next page to identify and replace a failed drive.

replace

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 50 51

Pas de commentaire

G-Technology G-Speed eS Pro Guide de l'utilisateur Page 33