G-Technology G-SAVE Guide de l'utilisateur télécharger pdf (Page 10)

e 10

G-SAFE Product Guide

3. Turn on G-SAFE (the alarm will sound and the display will

indicate a MISSING drive)

4. Mute the alarm by pressing the “MUTE” button on the front

panel.

5. Insert the target drive module while the unit is on. (This

could be the drive module you had stored offsite)

WARNING: The target drive you are inserting will

be overwritten with data from the source drive.

Be sure you are inserting the correct drive.

6. G-SAFE will ask if you would like to rebuild the array.

(in this case G-SAFE will rebuild from Drive 1 (top) to

Drive 2 (bottom)

7. Push the ENT button to begin the process or ESC button to

cancel (the process will automatically cancel in 10 seconds)

8. G-SAFE will now rebuild the data to the target drive.

9. Reset the “MUTE” button to re-enable the audible alarm.

Note: The rebuild process takes approximately one minute for

each 2.5 GB of storage capacity. So the rebuild time for a 250GB

drive is approximately 100 minutes.

10. Once the rebuild is complete, the LCD panel will display the

following message.

G-SAFE is now back to protecting your valuable data!

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 18 19

Pas de commentaire

G-Technology G-SAVE Guide de l'utilisateur Page 10